Loads of errors when saving

[N64squid]

I don't know if this is a common issue, but I keep on getting these errors when I save a blog post. Should I just go ahead and publish it?

Low-res:
http://i.imgur.com/kHaMygT.jpg

Hi-res:
https://www.mediafire.com/?2f8n4mwq0liljoy

[SirPsycho]

I got you covered.

http://www.rfgeneration.c...e-Wall-of-Errors-2749.php

[N64squid]

Thanks for getting back so fast!

[Edit]

I tried going through the instructions, but when I get to the part where it says "Click on Edit Entries.", it's all empty =/

[SirPsycho]

There could be more errors that have popped up since then. Its always a good idea to save your writing on your hard drive before you try and post it so it doesn't get lost forever. Shadow can go into more detail about what's wrong and how all this broke.

[N64squid]

Ok, cheers.

[Shadow Kisuragi]

Long story short, when we migrated servers we also updated the engine that our code runs off. Unfortunately, I wasn't aware that this was going to happen and it broke a lot of our site's functionality, including the blog system. We can disable the offending code, but it's used to remove any malicious HTML from the blogs. Fixing it requires some work, and we don't have a dev version of the site available to work in it (yet).

[N64squid]

Does that mean that if I hit 'Save and publish', it will still publish correctly? That's what I'm worried about.

[Shadow Kisuragi]

Since I've never done it as a non-Staff member, I couldn't tell you (it's off for Staff). I'll let SirPsycho chime in on that one.

[SirPsycho]

Does that mean that if I hit 'Save and publish', it will still publish correctly? That's what I'm worried about.

That's how I did it before I became an official blogger. Save and publish, then go to edit if it doesn't popup and publish it again.