Help with fixing a controller

[Jmmcwho]

I recently purchased a spongebob ps2 controller but it has a few spots where the black wire cover is split. How can I fix them without electrical tape? I was going to do heat shrink but I'm not sure how to disassemble  the plug end and I've never soldered anything before. Any help and advice is greatly appreciated

[shaggy]

Any pics you can post?  That may help with someone getting you more accurate information to help you.

[Jmmcwho]

I can't get pictures to load up

[bombatomba]

If already have a photo service, try looking for a "Forum" link, or just use the provided photo's URL in between IMG tags.  If you don't have an account with Photobucket or Flickr try out <a href:"http://tinypic.com/">TinyPic[/url].  You don't need an account to start.  Just click off the popups, click on "Choose File" then "Upload Now" (you may have to do a Capcha).  Select everything within the "IMG Code for Forums & Message Boards" box, and paste it here.

[Duke.Togo]

For something like this, I would use the cord from another junk controller and reattach it at the controller board. Many controllers have a plug on the board to disconnect the controller lead, so you may not need to solder.

[mumboking]

For something like this, I would use the cord from another junk controller and reattach it at the controller board. Many controllers have a plug on the board to disconnect the controller lead, so you may not need to solder.

Not as easy to replace when the plug is unique...

[Jmmcwho]

Yeah that's my problem. Just trying to fix the splits without damaging the controller but still being able to avoid electrical tape. Not big splits just 2 small one probably less than 1 inch each